WEKO3
アイテム
Accurate Geometric Transformation of Laser Scanner Data for Landslide Monitoring
http://hdl.handle.net/10173/1707
http://hdl.handle.net/10173/1707c07bbab7-7aaa-4882-8c36-d5693105c787
名前 / ファイル | ライセンス | アクション |
---|---|---|
SMS08-128.pdf (253.6 kB)
|
|
Item type | 会議発表論文 / Conference Paper(1) | |||||
---|---|---|---|---|---|---|
公開日 | 2018-02-06 | |||||
タイトル | ||||||
タイトル | Accurate Geometric Transformation of Laser Scanner Data for Landslide Monitoring | |||||
言語 | ||||||
言語 | eng | |||||
キーワード | ||||||
主題Scheme | Other | |||||
主題 | Landslide | |||||
キーワード | ||||||
主題Scheme | Other | |||||
主題 | Laser Scanner | |||||
キーワード | ||||||
主題Scheme | Other | |||||
主題 | Geometric transformation | |||||
資源タイプ | ||||||
資源タイプ識別子 | http://purl.org/coar/resource_type/c_5794 | |||||
資源タイプ | conference paper | |||||
著者 |
Miyazaki, Tomonori
× Miyazaki, Tomonori× Kinoshita, Kazu× Takagi, Masataka |
|||||
抄録 | ||||||
内容記述タイプ | Abstract | |||||
内容記述 | Landslide is a phenomenon of mass slowly movement in wide area. It is difficult to measure whole landslide area by using existing monitoring systems. Nowadays, ground based portable the laser scanner is expected to monitor landslide, because the laser scanner can acquire three-dimensional data of wide area in a short time. The acquired data by the laser scanner has own coordinates. The coordinate is called laser coordinate in this study. The laser coordinate must be transformed into the ground coordinates using Ground Control Point(GCP). The prism or reflector sheet is usually used as GCP. GCPs of ground coordinate can be precisely measured by total station. The laser coordinates of GCPs can be acquired automatically by image processing software of laser scanner. The image processing is based on reflection strength of the laser around the prism or reflector sheet. The reflection strength of the prism is higher than reflector sheet. Then prism can be set up widely. However, cost of the prism is so expensive that many prisms cannot be set up. On the other hand, cost of reflector sheet is so cheap that many reflector sheets can be set up. Therefore, the prism and the reflector sheet should be compared in order to establish accurate transformation method. In this study, 6 prisms and 16 reflector sheets were used for geometric transformation. The accuracy of geometric transformation was discussed. The required accuracy is 10mm of Root Mean Square Error(RMSE) for land slide monitoring. In the case of prisms, result showed 95.9mm RMSE. In the case of reflector sheets, result showed 25.0mm RMSE. Many reflector sheets were effective for accurate transformation. Repeat measurement will make accurate transformation by average calculation. The average calculation of 10 times measurement showed 5.4mm error. Therefore, this measurement method will be effective to monitor land slide. | |||||
書誌情報 |
Society for Social Management Systems Internet Journal 巻 4, 号 1, 発行日 2008-03 |
|||||
ISSN | ||||||
収録物識別子タイプ | ISSN | |||||
収録物識別子 | 2432-552X | |||||
著者版フラグ | ||||||
出版タイプ | VoR | |||||
出版タイプResource | http://purl.org/coar/version/c_970fb48d4fbd8a85 | |||||
出版者 | ||||||
出版者 | Society for Social Management Systems |